Bruno Independent Living Aids Inc PCB4950 Manual Do Utilizador
© 1998 BRUNO INDEPENDENT LIVING AIDS, INC.
18
INSTALLATION
INSTALL FOOT CLAMPS
RECHECK NOTE:
BEFORE TIGHTENING
THE BRACKETS
CHECK TO MAKE
SURE THAT THE
BUMPER WIRES ARE
NOT TRAPPED UNDER
BUMPER BRACKET AT
BUMPER BRACKET AT
LOWER LANDING
NOTE:
IF THREADED FASTENER
EXTENDS BELOW A
STAIR TREAD THAT IS
EXPOSED, IT CAN BE
TRIMMED FLUSH WITH A
PLIERS.
[ ] Check that the foot clamp base position is a minimum of
1/2" from the wall.
NOTE: THE STAIRWAY ELEVATOR COMES
WITH FASTENERS APPROPRIATE FOR WOODEN
STAIR TREADS ONLY. OTHER STAIR MATERIAL
MAY REQUIRE DIFFERENT FASTENERS (CONTACT
BRUNO INDEPENDENT LIVING AIDS FOR FURTHER
ASSISTANCE). (NOTE: FOR HARDWOOD STAIRS, IT IS
RECOMMENDED THAT A PILOT HOLE BE DRILLED
BEFORE SCREWING IN FASTENERS).
WITH FASTENERS APPROPRIATE FOR WOODEN
STAIR TREADS ONLY. OTHER STAIR MATERIAL
MAY REQUIRE DIFFERENT FASTENERS (CONTACT
BRUNO INDEPENDENT LIVING AIDS FOR FURTHER
ASSISTANCE). (NOTE: FOR HARDWOOD STAIRS, IT IS
RECOMMENDED THAT A PILOT HOLE BE DRILLED
BEFORE SCREWING IN FASTENERS).
[ ] Once rail position is confirmed, place one screw in each
bracket to hold rail in place while tightening to rail.
(This will prevent mounting feet from rotating while bolt is
being tightened.)
(This will prevent mounting feet from rotating while bolt is
being tightened.)
[ ] Tighten rail bolt and install the rest of the screws in
bracket, then tighten securely.
[ ] Install the upper bumper bracket to rail.
INSTALL THE UPPER BUMPER BRACKET
FIGURE 14