Zebra Technologies Corporation MD-ZLAN11G Manual Do Utilizador
Specifications
Power Cord
Power Cord
78
61207L-001 Rev. A
HC100 User Guide
4/23/08
Power Cord
Depending on how your printer was ordered, a power cord may or may not be included. If one
is not included or if the one included is not suitable for your requirements, see
is not included or if the one included is not suitable for your requirements, see
and
refer to the following guidelines:
• The overall cord length must be less than 9.8 ft. (3 m).
• The cord must be rated for at least 10 A, 250 V.
• The chassis ground (earth) must be connected to ensure safety and reduce electromagnetic
interference.
Figure 17 • Power Cord Specifications
Figure 18 • International Safety Organization Certifications
Caution •
For personnel and equipment safety, always use an approved three-conductor
power cord specific to the region or country intended for installation. This cord must use an
IEC 320 female connector and the appropriate region-specific, three-conductor grounded
plug configuration.
IEC 320 female connector and the appropriate region-specific, three-conductor grounded
plug configuration.
1
AC power plug for your country—This should bear
the certification mark of at least one of the known
international safety organizations (
the certification mark of at least one of the known
international safety organizations (
).
2
3-conductor HAR cable or other cable approved for
your country.
your country.
3
IEC 320 connector—This should bear the
certification mark of at least one of the known
international safety organizations (
certification mark of at least one of the known
international safety organizations (
).
4
Length
≤ 9.8 ft. (3 m). Rating 10 Amp, 250 VAC.
3
1
2
4