Zebra Technologies Corporation MD-ZLAN11G 用户手册

Specifications
Power Cord

61207L-001 Rev. A

HC100 User Guide

4/23/08

Depending on how your printer was ordered, a power cord may or may not be included. If one 
is not included or if the one included is not suitable for your requirements, see 

 and 

refer to the following guidelines:

• The overall cord length must be less than 9.8 ft. (3 m).

• The cord must be rated for at least 10 A, 250 V.

• The chassis ground (earth) must be connected to ensure safety and reduce electromagnetic 

interference.

For personnel and equipment safety, always use an approved three-conductor 

power cord specific to the region or country intended for installation. This cord must use an 
IEC 320 female connector and the appropriate region-specific, three-conductor grounded 
plug configuration.

AC power plug for your country—This should bear 
the certification mark of at least one of the known 
international safety organizations (

).

3-conductor HAR cable or other cable approved for 
your country.

IEC 320 connector—This should bear the 
certification mark of at least one of the known 
international safety organizations (

).

Length 

≤ 9.8 ft. (3 m). Rating 10 Amp, 250 VAC.