ADC Telecommunications Inc. PSM7A7UD Manual Do Utilizador
Connect the RF Module Cables
FlexWave Prism RF Modules for Prism Remote Units Installation Guide
Page 37
TECP-77-141 Issue 5 • 300001744178 Rev E • November 2013
© 2013 TE Connectivity Ltd.
Latches on Dual‐Slot 40W RF Modules
For Dual‐Slot 40W RF Modules, secure four latches, as shown in
Figure 20.
Dual-Slot 40W RF Module Latches
Verify that the RF Module Mounting Hook is Engaged
1
Verify that the RF Module Mounting Hook is engaged correctly by pulling the module away
from the heat sink. The RF Module should not move. If the RF Module moves during this check,
repeat all the steps starting at
from the heat sink. The RF Module should not move. If the RF Module moves during this check,
repeat all the steps starting at
through this step.
Connect the RF Module Cables
The steps to connect the RF Module cables have been separated into two different procedures;
follow the steps that correspond to the RF Module being installed.
follow the steps that correspond to the RF Module being installed.
•
•
.
Four latches in
a Dual-Slot 40W
RF Module
a Dual-Slot 40W
RF Module