N. V. Nederlandsche Apparatenfabriek NEDAP SENSITEPL Manual Do Utilizador
SENSIT SYSTEM | MANUAL
SENSIT Interface Software
57/92
13.5 DETECTION
13.5.1 DATA COLLECTOR
In the Data Collector menu you can configure communication gateway settings between
the Data Collectors and the SENSIT Server. Furthermore the screen provides an overview of
the current Data Collector settings. The list of Data Collectors is automatically updated.
Gateway server setting
Select 'enabled' to enable the connection from Data Collector to the server. Enter the TCP
port (or SSL port), to accept connections from the Data Collector(s). For a remote hosted
SENSIT Server, the port number should not be changed. Because the port numbers are
assigned by the Nedap system administrator.
Data Collector connection settings
In this menu you can set 'Host name' and communication 'Port' for the Data Collector. The
Data Collector is displayed as a node, see below. The hostname of the Data Collector can
normally be found on the housing. The SENSIT Server will try to establish a connection with
the specified Data Collector. This does not work on remote hosted SENSIT Servers. See
gateway server settings above.
The screen provides an overview of the current Data Collector settings. When entering new
Data Collectors, the table is automatically updated.
the Data Collectors and the SENSIT Server. Furthermore the screen provides an overview of
the current Data Collector settings. The list of Data Collectors is automatically updated.
Gateway server setting
Select 'enabled' to enable the connection from Data Collector to the server. Enter the TCP
port (or SSL port), to accept connections from the Data Collector(s). For a remote hosted
SENSIT Server, the port number should not be changed. Because the port numbers are
assigned by the Nedap system administrator.
Data Collector connection settings
In this menu you can set 'Host name' and communication 'Port' for the Data Collector. The
Data Collector is displayed as a node, see below. The hostname of the Data Collector can
normally be found on the housing. The SENSIT Server will try to establish a connection with
the specified Data Collector. This does not work on remote hosted SENSIT Servers. See
gateway server settings above.
The screen provides an overview of the current Data Collector settings. When entering new
Data Collectors, the table is automatically updated.
Figure 41: Data Collector gateway server settings
13.5.2 NODE CROSS CHECK
The menu option 'Node cross check' displays all nodes currently visible in the system that
are not allocated to a parking bay. These could be new or replaced SENSITs, but also the
Relay Nodes and Data Collectors are shown here. Moreover this screen also displays parking
bays without a node (if this information is entered via the parking bay configuration).
are not allocated to a parking bay. These could be new or replaced SENSITs, but also the
Relay Nodes and Data Collectors are shown here. Moreover this screen also displays parking
bays without a node (if this information is entered via the parking bay configuration).
Figure 42: Node cross check