Meko Lighting Company Limited RF433M Manual Do Utilizador
Indoor LED Flexible Lighting Strip
Important, Retain For Future Reference: READ CAREFULLY
Carefully follow the installation instructions below in order to ensure that this product functions safely
and properly for years to come.
Thank you for selecting DSI as your lighting choice for your home.
With proper care,
this product will provide years of pleasure and enjoyment.
USE & CARE GUIDE
ITM./ART.: 1234762
MODEL: DS18124
MADE IN CHINA
REVISE DATE: 03/28/2017
E
5101 NW 21st Ave, Suite 520, Ft Lauderdale, FL 33309 USA
DSI Customer Service Hotline: 1-800-388-6141 ext. 216 Mon.– Fri., 9:30 a.m. to 3:00 p.m. EST
Customer Service E-mail: CustomerSupport@DSILighting.com
5101 NW 21st Ave, Suite 520, Ft Lauderdale, FL 33309 USA
DSI Customer Service Hotline: 1-800-388-6141 ext. 216 Mon.– Fri., 9:30 a.m. to 3:00 p.m. EST
Customer Service E-mail: CustomerSupport@DSILighting.com
MODEL: DS18124
MODEL: DS18124
120VAC 60Hz
MADE IN CHINA
Page 12 of 12
Page 1 of 12
E
120VAC 60Hz
SAFETY INSTRUCTIONS FOR REMOTE
Safety instructions for remote
7
Push
Open
IC Statement
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
WARNING: The remote contains a CR2025 DC 3V button battery. If swallowed, it could cause severe injury or death in just 2 hours
.
Seek medical attention immediately.
Note: To replace the battery, please loosen the small screw on the back side of the remote, and refer to the diagram on the back side of
the remote.
Always purchase the correct size and grade of battery that is most suitable for the intended use.
Replace all batteries of a set at the same time.
Clean the battery contacts and also those of the device prior to battery installation.
Ensure that batteries are installed correctly with regards to polarity (+ and -).
Remove batteries from equipment when not used for an extended period of time.
Replace used batteries promptly.
WW
Flash
C
WW
Flash