Cisco Aironet 1410 Wireless Bridge AIR-BR1410A-E-K9 Manual Do Utilizador

This section lists new features in Cisco IOS Release 12.3(4)JA.

This feature enables SNMPv3 support on Cisco Aironet bridges to provide an additional level of
security.

This section contains important information to keep in mind when installing your bridge.

The bridge is available in two configurations:

Integrated antenna bridge (with 22.5-dBi directional antenna)

External antenna bridge (with antenna connector for use with an external antenna)

To meet regulatory restrictions, the external antenna bridge configuration and the external antenna must
be professionally installed.

When installing the dual-coax cable, it is acceptable to unzip or pull the two cables apart at the ends if
more separation is needed between the male F connectors.

Personnel installing the bridge must understand wireless bridging techniques, antenna alignment and
adjustment, and grounding methods. The integrated antenna configuration can be installed by an
experienced IT professional.

You can double the throughput or create a standby link by stacking two bridges. A stacked installation
consists of two bridge systems installed at the same physical location. For detailed mounting instructions
refer to the Cisco Aironet 1400 Series Wireless Bridge Mounting Instructions that shipped with your
bridge.

The bridge antennas must be separated by a minimum of 6.56 ft (2 m) from each other and from other
co-located antennas.