GSI ELECTRONICS INC. EDGERFID Manual Do Utilizador
CAUTION
Disconnect supply before servicing.
WARNING
When wiring is complete, close the enclosure and secure it with the four screw.
NOTICE
When tightening small terminal blocks, use a torque between 0.5N*m (4.43lbf*in) and
0.6 N*m (5.2lbf*in) to fasten a wire gauge from 16AWG to 18AWG.
0.6 N*m (5.2lbf*in) to fasten a wire gauge from 16AWG to 18AWG.
Refer to the wiring diagrams for more information.
Connecting the relay output
Before You Begin
IMPORTANT: A disconnect switch must be installed to interrupt Power to L1 and N/L2 electric Power
lines before connecting the system’s main inputs on the relay outputs. It must be in close
proximity to the equipment and within easy reach of the operator. It must be marked as the
disconnecting device for the equipment. From the Power source, follow the wiring diagram
to connect the main voltage supply to the relay output. GSI Electronics recommends using
a DPST disconnecting switch in series with a breaker. In the case of the use of a SPST dis-
connecting switch, connect SPST disconnecting switch to cut the hot line with a neutral cir-
cuit case.
proximity to the equipment and within easy reach of the operator. It must be marked as the
disconnecting device for the equipment. From the Power source, follow the wiring diagram
to connect the main voltage supply to the relay output. GSI Electronics recommends using
a DPST disconnecting switch in series with a breaker. In the case of the use of a SPST dis-
connecting switch, connect SPST disconnecting switch to cut the hot line with a neutral cir-
cuit case.
WARNING
If the disconnecting switch or the circuit breaker is used as a sectioning device, the
device must be correctly identified with which function of the controller opens the
circuit. The Off or Stop and On position must be clearly identified on the sectioning
device must be correctly identified with which function of the controller opens the
circuit. The Off or Stop and On position must be clearly identified on the sectioning
device.
CAUTION
Disconnect supply before servicing
1. From the power source, follow the wiring diagram to connect the main voltage supply to the relay
output.
2. Locate the “RELAY” terminals on the KP-8IN-1REL, TP-8IN-1REL, TR-2IN-1REL.
3. Connect the voltage source (L1 or 24V or 28V) wire needed to switch in the terminal block named
“RELAY – COM”
4. Connect one load from the relay output: terminal -RELAY - NO or terminal RELAY – NC.
5. From the load, connect to the main voltage supply return (L2/N) or the 24V return or the 28V return.
IMPORTANT: The maximum voltage on the relay outputs is 240Vac. The maximum current allowed
is 5A. The minimum permissible load on the relay outputs is 0,1A.
895-00695
21