GSI ELECTRONICS INC. EDGERFID Manual Do Utilizador
3
Maintenance
Topics Covered in this Chapter
Inspecting and cleaning the enclosure
Inspecting the enclosure and keeping them clean can help prolong the proper functioning of the module.
Before You Begin
CAUTION
Disconnect the voltage supply before servicing or performing any maintenance
operations.
operations.
WARNING
Screw the screw on the enclosure once the wiring is completed or when servicing.
• Every few months, open and inspect the enclosure for moisture or dust build-up.
• Using a damp cloth, wipe clean the exterior of the enclosure.
NOTE: Do not spray water on the controller.
Inspecting and tightening connections
At some point, the connections must be verified to ensure they are not loose and that the installation is
always safe. The inspection ensures that no overheating occurs on the tightening connections. GSI Elec-
tronics recommends verifying the connections on power and control terminals every 3-12 Months. The
torques are stated in the manual where tightening torque is required according to the specific terminal.
always safe. The inspection ensures that no overheating occurs on the tightening connections. GSI Elec-
tronics recommends verifying the connections on power and control terminals every 3-12 Months. The
torques are stated in the manual where tightening torque is required according to the specific terminal.
895-00695
23