Wago 759-302 COMMISSIONING TOOL I/O-CHECK 2 759-302 Ficha De Dados

Operation (Overview)    •  71 

Following steps are necessary to monitor or control inputs and outputs of a 
fieldbus node: 

Prepare communication connection , 

Determine node configuration , 

Select WAGO-I/O-CHECK operating mode , 

Select an I/O module , 

Display process data of the selected I/O module , 

Set output process data of the selected I/O module , 

and (if necessary) 

Change parameters of the selected I/O module . 

 

Note: 
Only for a node with MODBUS connection: 
Set the coupler/controller station switch to ´00´. 

 

Note: 
Only for a node with CAN connection: 
For couplers a COB-ID must be selected between 1 und 126. 

 

Note: 
For the start-up of a node with a praogrammable fieldbus controller it is 
necessary to stop the programm processing (cycle) in the controller (stop 
state)! For this move the slider next to the configuration interface to the 
middle setting. 

The following steps are necessary to prepare a communication connection: 

•  Switch off the voltage supply of the buscoupler / -controller. 
•  Open the cover of the configuration interface of the buscoupler / -

controller.