Wago 759-302 COMMISSIONING TOOL I/O-CHECK 2 759-302 Ficha De Dados
Códigos do produto
759-302
Operation (Overview) • 73
Select WAGO-I/O-CHECK Operating Mode
WAGO-I/O-SYSTEM 759
WAGO-I/O-CHECK 2
Note:
A coupler does not recognize passive I/O modules. Therefore these
modules are not displayed by WAGO-I/O-CHECK.
A coupler does not recognize passive I/O modules. Therefore these
modules are not displayed by WAGO-I/O-CHECK.
The node will be displayed as a tree structure in navigationbar and as a graphic
view in the node display area.
view in the node display area.
5.3 Select WAGO-I/O-CHECK Operating Mode
WAGO-I/O-CHECK provides the operation modes Control-Mode ´Direct´,
Control-Mode ´Collect´, Control-Mode ´Force´, Control-Mode
´Permanent´ and Monitor-Mode for the controlling and monitoring of the
process data.
Control-Mode ´Collect´, Control-Mode ´Force´, Control-Mode
´Permanent´ and Monitor-Mode for the controlling and monitoring of the
process data.
The operaton modes Control-Mode are used to monitor input and output
process data as well as to control output process data. It is necessary to
deactivate the fieldbus and to switch off PLC-functions (if a controller is
connected) to control output data.
process data as well as to control output process data. It is necessary to
deactivate the fieldbus and to switch off PLC-functions (if a controller is
connected) to control output data.
Select the operation mode Control-Mode ´Direct´ if outputs shall be set with a
mouse click and be reset with the next mouse click on the corresponding
control element.
To set this operation mode,
mouse click and be reset with the next mouse click on the corresponding
control element.
To set this operation mode,
• select the menu command Node\Control-Mode\Direct or
• click the command Direct from the dropdown list next to the symbol
from the toolbar Node or
• enter the shortkey <Ctrl> + <Shift> + <D>.
To set more then one output at the same time select the operation mode
Control-Mode ´Collect´. You can arrange various output states and send them
to the node with a mouseclick on the button S
Control-Mode ´Collect´. You can arrange various output states and send them
to the node with a mouseclick on the button S
END
D
ATA
.
To set this operation mode,
• select the menu command Node\Control-Mode\Collect or
• click the command Collect from the dropdown list next to the symbol
from the toolbar Node or
• enter the shortkey <Ctrl> + <Shift> + <C>.
Select the operation mode Control-Mode ´Force´ if a digital output is to be
active as long as a mouse key is pressed.
To set this operation mode,
active as long as a mouse key is pressed.
To set this operation mode,
• select the menu command Node\Control-Mode\Force or