Wago 759-302 COMMISSIONING TOOL I/O-CHECK 2 759-302 Ficha De Dados

74  •    Operation (Overview) 

 

•  click the command Force from the dropdown list next to the symbol 

 

from the toolbar Node or  

•  enter the shortkey <Ctrl> + <Shift> + <F>. 
 

If the output states are to remain in their current state after the termination of 
the connection between WAGO-I/O-CHECK and the node, select the 
operation mode Control-Mode ´Permanent´. A reset of the coupler / controller 
resets the outputs if the node is not connected to WAGO-I/O-CHECK. 
To set this operation mode, 

•  select the menu command Node\Control-Mode\Permanent or  

•  click the command Permanent from the dropdown list next to the symbol 

 from the toolbar Node or  

•  enter the shortkey <Ctrl> + <Shift> + <P>. 
 

Select the operation mode Monitor-Mode if input and output data shall only be 
monitored and no output control is desired. 
To set this operation mode, 

•  select the menu command Node\Monitor-Mode or  

•  click the symbol 

 from the toolbar Node or  

•  enter the shortkey <Ctrl> + <Shift> + <M>. 
 

To change the operation mode of WAGO-I/O-CHECK simply enter to the 
corresponding command of the menubar or toolbar. 

To switch off the active operation mode enter the corresponding command 
again or press <F10>. 

Press <F9> to switch on the last selected operation mode again. 

WAGO-I/O-CHECK provides the following methods to select a I/O module: 

•  Click the required I/O module in the graphic. 
 
Keyboard 

•  Use the keys <Ctrl> + <!> to select the next I/O module or 

•  use the keys <Ctrl> + <"> to select the previous I/O module or