Protection 1 ProtectionOne Security System 250P1 Manual Do Utilizador

If the Paging feature has been programmed for your system, your
pager will respond to certain conditions as they occur in your system.
This message appears in a 7-digit format explained below.  You can
also send up to 16 additional digits that may consist of PIN numbers,
messages, reminders, etc.  These 16 digits are programmed by your
installer and will appear before the standard 7-digit message.

The pager button, when pressed (if available), sends a special
message to a pager and displays Pager Msg sent on the keypad for
30 seconds (on an alpha keypad). The message it sends is coded as
999-9999 and signifies ANY message the user and recipient have
decided is appropriate.

The 7-digit condition code that follows takes the following form:

SSS = 

3-digit event code: 911 = Alarm

811 = Trouble
101 = Opening (disarm)
102 = Closing (arm AWAY)

00EE = The first 2 digits will always be 00. They are followed by the

2-digit user number or zone number, depending on the event
code.

Pager displays:  911–0004  . This indicates that your system is

reporting an alarm (911) due to a fault in zone 4 (04). Alarm and
trouble codes are always followed by the zone numbers in which they
occur.

Note:  If special 250P1 function keys are used, reports other than
those listed above are possible.  They have settable codes between
750-789.  Ask your installer if these codes have been enabled.