BMW 2004 X3 3.0i SAV Manual Do Proprietário

Reference

At a glance

Controls

Driving tips

Mobility

Replacing components

Onboard tool kit

The onboard tool kit is located in a com-
partment on the left under the cargo area.

Replacing wiper blades

Front

Move the wiper to a fold-out position,
refer to page

Lift the wiper arm and press the secur-
ing spring, refer to arrow

Pull the wiper blade off toward the
wiper arm

Insert the new blade and snap it into
place.

Fold the wipers back down onto the
windshield before you turn the igni-

tion key to position 1 or 2 again. If you do
not, they could be damaged.

Rear

Lift the wiper arm

Pull off the wiper blade, refer to arrow

Insert a new wiper blade.

Lamps and bulbs

The lamps and bulbs make essential contri-
butions to the safety of your vehicle. There-
fore, comply fully with the following instruc-
tions during bulb replacement. If you are
not familiar with the specified procedures,
BMW recommends having the replace-
ments carried out at your BMW Sports
Activity Vehicle Center.

Never touch the glass of new bulbs
with your bare fingers, as even minute

amounts of contamination will burn into the
bulb's surface and reduce its service life.
To install, use a clean cloth, napkin etc. or
hold the bulb by its metal socket.

A replacement bulb set is available from
your BMW Sports Activity Vehicle Center.

To prevent short circuits, before
working on any electrical system,

equipment or accessory you should always
switch it off and disconnect the cable from
the battery's negative terminal before start-
ing.
To avoid possible injury or equipment dam-
age when changing bulbs, observe any
instructions provided by the bulb manufac-
turer.