Electrolux OHV Manual Do Utilizador

24

25

6.23 Adjustment for Auger Control Rod
* The Auger Control Rod is on the handle at the 
right side of the operator.  

if engagement is sluggish or if the auger does 
not stop within 5 seconds of the release of the 
auger engagement lever.

6.24 Adjustment for Speed Control Rod
* The Speed Control Rod is attached to the speed 
selector at the right side of the operator console.  
Adjustment is required when there are less than 
two speed positions for reverse.

* Raise protective Spring Sleve to expose jam nut.
* Loosen the jam nut.
* Remove hairpin and disconnect control rod from
   control lever. 
* Turn the rod counter-clockwise to lengthen,       
   clockwise to shorten.  
* Reconnect the control rod to the control lever.  

              

 

   The linkage should be slightly loose. If not 
   readjust, then tighten jam nut. 
* Test auger disengagement.  Stopping time must  
   be 5 seconds or less.
* If stopping is more than 5 seconds, readjust rod  
  for more slack.  Remove belt cover and check to  
  see if idler arm will move freely by engaging auger  
  control lever.  Retest stopping time.

* Loosen the nut and bolt at the middle of the rod.
* Hold Bellcrank Shifter (p 35 key 33) in maximum 
  counterclockwise position with one hand, and 
tighten the nut and bolt with other hand.

* Speed Control in last notch ( 2nd reverse position)

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

www.mymowerparts.com