Electrolux OHV Manual Do Utilizador
26
27
6.31 Adjustment for Power Steering Slips
* Operate to determine which side is slipping.
* Operate to determine which side is slipping.
* Measure the gap between the Wheel Lobe (part
179136) and the Retaining Ring (key 33).
* If the gap is .030" or more, install an additional
174697 Hardened Thrust Washer next to the
Axle Bearing to eliminate slip.
* Reinstall all parts with needed thrust washers.
* Use antiseize compound on splined parts
during reassembly. Refer to page 33 for
exploded parts view.
179136) and the Retaining Ring (key 33).
* If the gap is .030" or more, install an additional
174697 Hardened Thrust Washer next to the
Axle Bearing to eliminate slip.
* Reinstall all parts with needed thrust washers.
* Use antiseize compound on splined parts
during reassembly. Refer to page 33 for
exploded parts view.
* Reinstall Thrust Washer (p 37 key 27), Axle Lobe
(26), Wheel Lobe (23), and Retaining Ring (key 33).
* Pull axle shaft outward to maximize tolerances.
(26), Wheel Lobe (23), and Retaining Ring (key 33).
* Pull axle shaft outward to maximize tolerances.
* Remove wheel and power steering parts on side
with slipping power steering, Section 7.22.
with slipping power steering, Section 7.22.
* Place Snowthrower with Auger end down.
FEELER GAUGE
RETAINER RING
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com