Electrolux OHV Manual Do Utilizador

40

41

1)   Remove fuel from fuel tank.
2)   If repair involves removal of  Drive Plate 

Assembly.  See section 7.45.

3)   Remove Belt cover.  Use tape to hold  end of  

Drive Belt Idler Spring in place, see page 37.

4)   If the Drive Plate Assembly is to be removed, 

use a 3/8" drive ratchet with a 6" extension to 
remove tension from the traction drive belt by 
pulling up. Remove belt from engine pulley, see 
Section 7.34.

7.43 Replace Rubber Wheel Ring or 
Hex Shaft

1)   Remove wheels
2)   Remove bottom pan (Section 7.42)

5)   Position snowthrower so auger is down and 

handles are up.

6)   Remove both wheels
7)   Remove the four Hex Head Screws that hold 

the bottom pan to the frame.

8)   Reverse to reassemble.

5)   Pull bearing/hex shaft assembly out from left 

side.

6)   Remove Assembly with Rubber Wheel Ring 

from shifter fork and support Plates.

7)   Replace Rubber Wheel Ring and torque 

bolts to 14-18 Ft.Lbs.

8)   Reverse process to install. Lubricate hex 

shaft with metallic anti-seize before re-
installing.  Check to see that trunion bearing 
round tabs are positioned in slots of shifter 
fork.

3)   Using a 3⁄4” wrench to hold the shaft ,  

remove nut on right side

4)   Remove both screws that secure flange 

bearing on left side.

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

www.mymowerparts.com