Electrolux OHV Manual Do Utilizador

40

41

1)  Remove bottom pan (Section 7.42).
2)   Remove bolts holding lower handle to left 

side of frame.

3)  Remove four 1⁄2” nuts that secure the gear 

and the Auxiliary Plate.

4)  Remove bolt through center of gear.   

NOTE:  Inspect pinion on Hex Shaft, if 
damaged replace. Lubricate Hex Shaft.

5)  Replace gear and reassemble reversing the 

process.  Torque nuts at 

     Lubricate center of gear with grease.

1)  The Drive Belt must be removed from the 

Engine Pulley.   (Section 7.32)

2)  If equipped with power steering, remove the 

screw holding the power steering cover at 
lower front on both sides. 

3)  Remove the 1⁄2” nut holding the clutch rod to 

the drive control bellcrank.

4)  Remove the 4 screws (2 each side) from 

the frame that hold the mounting drive plate 
in place. The zinc plated screws on left side 
are slightly longer.

5)  Remove belt from pulley
6)  Slide Drive Plate Assembly out.
NOTE:  Whenever this assembly is removed, 

it is strongly suggested to lubricate the 
Hex Shaft with anti-seize compound.   See 
Section 7.46 for instructions.

7)   Place belt on pulley in correct position, be 

sure the clutch rod is through the hole in 
top left end of plate.  Reverse the order to 
reassemble.

8)   The top left corner of the Drive Plate 

Assembly will fit into Frame Slot.

9)   Install 1⁄2” nut at bellcrank so two threads are 

showing on clutch rod. See Section 6.22

.

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

www.mymowerparts.com