Electrolux OHV Manual Do Utilizador

42

43

1)  Remove Frame Bottom Pan. Section 7.42.
2)  Remove covers and disassemble power 

steering on both sides if so equipped.

4)  Inspect parts for wear and replace if 

necessary.

5)  Lubricate all sides of Hex Shaft with metallic 

anti-seize compound.

6)  Reverse the order to reassemble.

NOTE: Lubrication of the Hex Shaft with 
metallic antiseize compound is recommended 
every 120 hours of operation. 

1)  Unhook Spring from Clutch Rod (key 11)
2)  Remove Hairpin Retainer (key 22) from the 

Shift Plate Lever.

3)  Remove Pivot Pin and separate Drive Plate 

(key 26) from hex shaft.

4)  Slide the axle out the right side and replace 

damaged parts.  

5)   Reverse process to reassemble.  Make 

sure the square key, roll pin, and thrust 
washer is located between gear and 
bearing

3)  Remove the screws on the right side that 

secure axle bushing to the frame.

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

www.mymowerparts.com