Monogram ZV800SJSS Instrução De Instalação

• With the template taped in place, use a punch to

mark all mounting screw locations.

• Drill 1/8” pilot holes at the 6 punched locations.
• Remove the template.
• The 2 holes in the support bracket holes must enter

studs or the horizontal support.

• Use wood screws to secure the mounting bracket to 

the wall. The screws must engage wall studs or the
installed horizontal mounting support. 

• Check to be sure that the bracket is level. 

There is no way to level the hood after hanging 
it from this bracket.

• Remove the hood from the box. Remove packaging

and tape.

• Remove one screw on each side of the cover on the

electrical panel. Lift off the cover and set aside with
screws.

• Stand the electrical panel upright.
• Align the screw holes in the bottom of the panel with

the holes on the base of the hood at the front side.

• Install 3 screws provided.
• Snap the damper into the 

exhaust outlet on the top of
the hood.

Remove 2 side

cover screws

Install

damper

Electrical

panel

Secure

electrical panel

with 3 screws

Junction box

Inside screw