Monogram ZV800SJSS Instrução De Instalação

• Place the decorative duct

covers on top of the hood.

NOTE: The inside (upper) 
duct piece has holes on one
end. The holes are intended
for use when the hood is
installed for recirculating
purposes. Slide the vented
end into the outer piece, 
the vent holes should not 
be visible in this installation.

The inside duct piece must slip into the folded ends of
the outer section.

• Extend the inner duct upwards to the ceiling bracket.

• Secure duct cover to ceiling bracket with 2 screws.
• Secure the lower duct cover to the hood by 

installing 2 screws from the bottom of the hood 
into the duct cover.

Mounting

screws

• Remove protective film on the filters.

• Tip the filter into the slots at the rear of the opening.

Lift the filter lock and pull forward until the filter
rests in the slots.

• Install both metal grease filters.
• To remove the filters, press inwards on the handle

and pull the filter downwards.

• Remove all packaging materials.
• Refer to the Owner’s Manual for operating

instructions.

Filter Locks

NOTE: The charcoal filter is not required for this installation.

Install 2 screws,

duct cover and

into ceiling

bracket

Install 
2 bottom 
duct cover 
screws