Dacor DR30DLP Instrução De Instalação
7
Installation Instructions
Parts List
2 grates
•
1 small standard burner cap
•
1 small standard burner ring
•
2 large standard burner caps
•
2 large standard burner rings
•
1 inner SimmerSear™ burner
•
cap
1 outer SimmerSear burner
1 outer SimmerSear burner
•
cap
1 SimmerSear burner ring
1 SimmerSear burner ring
•
Preparing for Installation
WARNING
If the gas or electric service provided does not meet the
•
product specifications, do not proceed with the installation.
Call the dealer, the gas supplier or a licensed electrician.
Before installing the range, you must locate and secure the
Before installing the range, you must locate and secure the
•
anti-tip bracket to the floor.
Be sure that the unit is not connected to gas or power
Be sure that the unit is not connected to gas or power
•
before proceeding with the following sections.
IMPORTANT: Within the Commonwealth of Massachusetts, this
appliance must be installed by a licensed plumber or gas fitter.
Unpacking the Range
Unpack the range and verify that all required parts have been
provided. If any item is missing or damaged, please contact
your dealer immediately. Do not install a damaged or incomplete
appliance. The customer must report cosmetic issues within 30
days of installation.
Level and Adjust the Range Height
Raise or lower the range to prepare for final installation. Adjust the
legs until the top edge of the trim around the edge of the cooktop
is slightly higher than the countertop.
Install the Anti-Tip Bracket and Foot
Locate the anti-tip foot and lower it until it is 1/16” (2 mm) off
1.
the floor.
Locate the anti-tip bracket included in the parts box.
2.
Install the anti-tip bracket on the floor using the four (4)
3.
included screws. See the diagram below for location.
ANTI-TIP BRACKET PLACEMENT
A
4” (10.2 cm)
B
4 1/4” (10.8 cm)
Anti-tip
foot
Back of
range
up
down
Back of range
2 1/8” *
* Distance to floor:
2 7/8” (7.3 cm) to 5” (12.7 cm)
Rear leg
B
Right side
of range
Back of
range
Top view
Bracket
A
Optional Backguard/Island Trim Installation
When used, the optional island trim or optional 6 or 9 inch
backguard must be installed before sliding the range into
place. Install them according to the accompanying installation
instructions.
3 standard racks
•
Anti-tip bracket w/screws
•
Meat probe
•
Dacor Stainless Steel
•
Cleaner
Literature kit
Literature kit
•