Honeywell XL 800 SERIES Manual Do Utilizador

 

Excel 800 

EN1B-0410GE51 R0908A 

 

32

Normal operation 

No action necessary 

Watchdog alarm output is powered 

–  The controller has encountered a 

hardware problem 
- or - 

–  The application has a fault 

- or - 

–  The controller has been powered up 

without an application or the operator 
has manually stopped the application,  
e.g., using XL-Online. 
In this case, the LED will light up 
13 minutes after power-up without 
application 

► 

Try powering down and then 
powering up the XCL8010AU. 

► 

If problem persists, check and – if 
necessary – reload the application. 

► 

If problem still persists, replace 
hardware 

Although the controller has encountered a 
problem, the watchdog alarm output has not 
yet been powered. 
If problem persists, the LED will become lit 
constantly, see case #2. 
The controller performs a warm start. 

If it happens only once, the controller 
has performed a restart 
If, however, it happens multiple times, 
then there is an application or hardware 
problem (see case #2) 

 

 

 

 
The L

ON

W

ORKS

 service LED of the XCL8010AU Controller Module displays the following flashing patterns indicating possible 

failure modes: