Middleby Marshall 60254 Manual Do Utilizador

P/N 60254 September 28, 2012

NOTE:  DO  NOT  install  top  panel  onto  double  or  triple  

ovens  until  AFTER  stacking  the  oven  cavities.  See 

Part B, Stacking.

B. Stacking
For  single  ovens,  skip  ahead  to  Part  C,  Restraint  Cable  

Installation.

IMPORTANT
Middleby Marshall STRONGLY RECOMMENDS that PS740 

Electric oven cavities be stacked BY AUTHORIZED PERSO-

NEL.

Contact your Middleby Marshall Authorized Service Agent for 

complete stacking instructions.
1.  Stack an oven cavity on top of the lower oven. Check  

the following:

•  All four sides of the lower lip (on the bottom edge of 

the oven cavity) overlap the top of the lower oven

•  The oven is level

•  The oven is firmly seated

 

See Figure 2-9.

2.   For  triple  ovens,  repeat  Step  1  to  install  the  top  

oven cavity.

3.  Install the top panel using the screws included in the base 

pad kit, as shown in Figure 2-10.

C.  Restraint Cable Installation
Because the oven is equipped with casters, a restraint cable 

assembly must be installed to limit the movement of the appli-

ance. One end of the cable is anchored to the eyebolt on the 

rear surface of the oven’s base pad, while the other is anchored 

to the wall.  See Figure 2-11.
After connecting the restraint cable, move the oven to its final 

location. Adjust the bottom (hex) sections of the feet so that  

the  casters  are  off  the  floor.  For  quad  ovens,  lock  the  two  

front casters.

#10-32 × 3/4″ 

screw length

Top 

panel

Wall of structure

Restraint cable assembly

3/4″ (19mm) 

eyebolt

3/8″-18 × 1″

eyebolt on  

rear leg  

extension

#10-32 × 2-1/2″ 

screw length