EnGenius Technologies IEEE 802.11b Outdoor Wireless Client Bridge Manual Do Utilizador

 
The Wireless client bridge supports access to the configuration system 
through the use of an HTTP Interface. 
 

„ 

Before configuring Wireless client bridge, user needs to know the IP 
Address assigned to the unit. When shipped from the factory, the IP 
Address 192.168.5.99 was assigned to the Wireless client bridge by 
default. To start a web connection, use http://192.168.2.1 
 

„ 

However, user may change the IP Address later and cannot connect the 
unit by using the default IP Address. In this case, it is a must to identify the 
Wireless client bridge current IP Address before configuring. To identify the 
IP Address, user can use the serial port (refer to 

) to gain access of 

the current network status.  
 
To start a Serial Port connection by following the steps below. 
 
Step 1  Attach the RS-232 null modem console cable (refer to 

 and 

) to the RS-232 Console Port on Wireless client bridge. 

Connect the other end to a terminal or a PC running a terminal 
emulation program. 

 
Step 2  Set the terminal to 115200 baud rate, None Parity, 8 data bits, 1 

Stop bit, and ANSI compatible. 

 
Step 3  Run a terminal emulation program on PC, such as Hyper 

Terminal, and set the following connection properties. 

Step 3.1 Click the Start icon > Program > Accessories > 

Communication > Terminal.  

 
Step 3.2  Create a new connection file, and select a Com Port 

<COM1, COM2, etc., depending on PC> with 
115200bps / 8-bits / 1-stop.  

 
Step 3.3  Click the properties icon in the Tool Bar > setting > 

select Emulation terminal VT100 > ok. 

Step 4  Reboot Wireless client bridge.  
 
Step 5  When the Wireless client bridge is powered up, the “Current 

Network Status” will be displayed as shown below. 

 

„ 

Once you identify the IP Address assigned to Wireless client bridge, use 
web browser to configure Wireless client bridge through the HTTP 
Interface. The following procedure explains how to configure each item. 
 
Step 1  Open your browser and enter the IP Address 
 
Step 2 Press <ENTER> key and the Wireless client bridge Login screen 

appears as shown below.