EnGenius Technologies IEEE 802.11b Outdoor Wireless Client Bridge Manual Do Utilizador

„ 

IP Use MAC Addr. 

You can choice Enable or Disable. If you choice Enable , it will set IP = 
10.X.X.X that used to last 3 MAC Address ID. 
For example :  
MAC Addr = 00:47:55:43:43:49 => IP = 10.67.67.73(43hex=67decimal) 
 If you choice Disable you need setting Bridge IP Address Information. 
 

„ 

Bridge IP Address  

Use this setting to assign or change the Wireless client bridge IP address.

 

„ 

Bridge Subnet Mask 

Enter an IP subnet mask to identify the sub network so the IP address can 
be recognized on the LAN. 

 

„ 

Enter the default Gateway IP Address, and click FINISH at the bottom of 
this page to complete the modification of this page. 

 
The Wireless client bridge supports 64-bit and 128-bit WEP encryption. 
 
For 64-bit WEP encryption, an encryption key is 10 hexadecimal characters 
(0-9 and A-F) or 5 ASCII characters. 
 
For 128-bit WEP encryption, an encryption key is 26 hexadecimal 
characters or 13 ASCII characters. 
 
Modify the WEP encryption parameters on the web page “/General 
Config/Woreless/”. Enter 1~15 characters into the WEP Key field, and 
click KeyGen to generate the WEP64 or WEP128 key patterns. 
 

 
Enter the Utility > Administration page. The figure below shows the 
Utility/ Administration page. 

 

 

„ 

Change the supervisor’s user name and password in the Supervisor 
Account field, and click FINISH to take effect on the previous configuration 
changes. 
 

„ 

Step 1 Enter the Utility > Administration page, select the Save then 

Restart to apply the new configuration settings. 

Step 2 Click FINISH to take effect on the previous configuration changes. 

Hint: It takes about 10 seconds, to complete the restart process.