Справочник Пользователя для Pelco C490M-D (1/96)
Pelco Manual C490M-D (1/96)
3
Figure 1. HS1000 Dimension Drawing
4.1 CEILING MOUNTING (FLUSH)
To mount the enclosure to a wall/ceiling, perform the
following steps:
following steps:
1.
Open the front cover by removing the four (4) 1/4-
20 “Tampruf” screws. A special socket is provided
(fits 1/4-inch square drive). The cover hinges down.
20 “Tampruf” screws. A special socket is provided
(fits 1/4-inch square drive). The cover hinges down.
2.
Using the mounting bracket as a template, mark
and drill holes in the mounting surfaces.
and drill holes in the mounting surfaces.
3.
Attach the enclosure with the required fasteners.
4.
Route required cables through the back and/or top
of the enclosure.
of the enclosure.
5.
Mount the camera/lens to the tilt table.
6.
Make all appropriate connections (i.e., camera
power, video (coax), lens, speakers, infrared illu-
minators, heater/power kits).
power, video (coax), lens, speakers, infrared illu-
minators, heater/power kits).
7.
Position the camera and tighten the 1/4-20 fasten-
ers to secure the tilt table in place.
ers to secure the tilt table in place.
8.
Close the cover and check that all components clear.
Secure the cover with the four (4) 1/4-20 “Tampruf”
screws provided.
Secure the cover with the four (4) 1/4-20 “Tampruf”
screws provided.