Справочник Пользователя для Teledyne gfc 7000ta

 

Teledyne Analytical Instruments 

36 

1.  After the analyzer’s components has warmed up for at least 30 minutes, verify that the software 

properly supports any hardware options that were installed.   

2.  Check to make sure that the analyzer is functioning within allowable operating parameters.  

Appendix C includes a list of test functions viewable from the analyzer’s front panel as well as 
their expected values.  These functions are also useful tools for diagnosing performance 
problems with your analyzer (Section11.1.2).  The enclosed Final Test and Validation Data sheet 
(part number 04307) lists these values before the instrument left the factory. 

To view the current values of these parameters press the following button sequence on the analyzer’s 
front panel.  Remember until the unit has completed its warm up these parameters may not have 
stabilized.   

 

 

 

 SAMPLE       

      CO2 = XXX.X 

 
 

  

  CAL 

 

 

 

SETUP 

Only appears instrument is set 

for DUAL or AUTO reporting 
range modes. 

2

 Only appears if O

2

 Sensor 

Option is installed. 

Refer to 

Table 6-2 for 

definitions of 

these test 

functions. 

Toggle <TST TST> buttons 

to scroll through list of 

 

If your network is running a dynamic host configuration protocol (DHCP) software package, the 

Ethernet feature will automatically configure its interface with your LAN. (See Section 6.11.6.2). 
This configuration is useful for quickly getting an instrument up and running on a network. 
However, for permanent Ethernet connections, a static IP address should be used. (See Section 
6.11.6.3).