Справочник Пользователя для Majestic Appliances 360DVS2

13

This appliance may be fitted with a Honeywell ignition 
module. 
Installation of the remote ON/OFF starter switch on 
electronic ignition units (Fig. 12): 
1.  Thread the wiring through the holes on the side 

panels of the appliance. Take care not to cut the wire 
or insulation on metal edges. Route the wire to a 
conveniently located receptacle box.

2.  Attach the wire to the ON/OFF switch and install the 

switch into the receptacle box.

3.  Connect the white wire from the wall switch to the 

black wire from the transformer, using an approved 
wire nut. Connect the black wire from the wall switch 
to the black wire running from the #6 position of the 
ignition module, also using an approved wire nut.

1    2    3          5    6    8     9

FP1225

Fig. 12  Honeywell ignition module.

Your fireplace is approved to be vented either through 
the side wall, or vertically through the roof.

• 

Only CFM Corporation venting components, specifi-
cally approved and labeled for this fireplace, may be 
used.

• 

Venting terminals shall not be recessed into a wall or 
siding.

• 

Horizontal venting must be installed on a level plane 
without an inclining or declining slope.

There must not be any obstruction such as bushes, 

garden shed, fencing, deck or utility building within 24” 
(610mm) from the front of the termination hood.
Do not locate the termination hood where excessive 
snow or ice buildup may occur. Be sure to check the 
vent termination area after snow falls; clear it to prevent 
accidental blockage of the venting system. When using 
a snow blower, make sure snow is not directed toward 
the vent termination area. 
Location of Vent Termination
It is imperative the vent termination be located observ-
ing minimum clearances as shown on the following 
page.