Справочник Пользователя для Multi Tech Equipment MLT20DCA
MLT20 seRIes LIgHT TOWeR • OpeRaTIOn ManuaL — Rev. #0 (01/18/13) — page 21
2. Adjust the Voltage Regulator Knob to 120VAC. Check
the AC voltmeter for the correct reading. See Figure 9.
Figure 9. Voltage Regulator Knob and AC
Voltmeter
3. Switch the appropriate circuit breakers to the ON
position for the lamps (Figure 10) that you want to turn
on as detailed in Table 3.
Figure 10. Lamp Orientation (MLTDCA6)
DECREASE
INCREASE
AC Voltmeter
Voltage Regulator
LAMP 1
LAMP 2
LAMP 3
LAMP 4
LAMP 5
LAMP 6
REAR
FRONT
MAST RAISED
OperatiOn
4. When the lamps turn on, check the AC voltmeter
reading and adjust the Voltage Regulator knob, if
necessary, to correct the voltage.
5. If any of the lamps do not turn on as they should, refer
to the troubleshooting section of this manual.
6. Close all cabinet doors after desired lights are on.
NOTICE
neveR operate the light tower with the engine
compartment doors open. Operation with the doors
open may cause insufficient cooling to the unit, and
damage may result.