Справочник Пользователя для Multiquip LS600P

This section is intended to make sure the cooling fan is 

working properly. Under normal conditions the fan should 

be running any time the engine is turned on.

1.  To determine the pressure of the hydraulic system, 

set the 

cylinder stroke control switch (Figure 57) to 

the 

JOG position.

2.  Place and hold the 

(Figure 58) to either 

JOG “A” or JOG “B” position to 

test the pressure of that cylinder.

If the hydraulic oil temperature exceeds 170° F (77° C), 

shut down the pump. 

DO NOT continue to operate the 

pump. Failure to shut down the pump will result in severe 

damage to the pump.

AUTOMATIC

JOG

CENTER

OFF

JOG

“A”

JOG

“B”

CYLINDER STROKE

3.  The

 pumping pressure gauge (Figure 59) should 

read approximately 4300 ~ 4400 PSI.

 

„

Remove the battery.

 

„

Drain the fuel tank completely. Treat with a fuel stabilizer 

if necessary. 

 

„

Clean exterior with a cloth soaked in clean oil. 

 

„

Store unit covered with plastic sheet in moisture and 

dust-free location out of direct sunlight.

1.  Check brake system for proper fluid level in master 

cylinder and bleed all lines.

2.  Lubricate all links and pivots to prevent any rusting.
3.  Remove wheel and drum assemblies and spray a good 

anti-corrosion compound (CRC formula 5-56) under 

rubber boot on forward end of brake wheel cylinder. 

Avoid spraying drum and brake lining.

4.  Grease all bearings and reinstall wheel and drum 

assemblies.

5.  Make sure breakaway cable is fully released.
6.  After extended storage, refer to the Maintenance Steps 

listed above to insure that the trailer is ready for towing.

0

PUMPING

PRESSURE

1000

2000

3000

5000

4000

NeveR store the pump with fuel in the tank for any 

extended period of time. 

ALWAYS clean up spilled 

fuel immediately.