Справочник Пользователя для Mitsubishi Electronics MR-J3
16 - 22
16. INDEXER POSITIONING OPERATION
16.2.5 Respond codes (RWrn 2)
If any of the monitor codes, instruction codes, Next station, Point table Nos./Speed command data set to the
remote register is outside the setting range, the corresponding error code is set to respond code (RWwn 2).
"0000" is set if they are normal.
remote register is outside the setting range, the corresponding error code is set to respond code (RWwn 2).
"0000" is set if they are normal.
Error related to Monitor code 1/Monitor code 2
Error related to Instruction code/Writing data
Error related to Next station
Error related to point table No./Speed command data
Code No.
Error
Details
0
Normal answer
Instruction was completed normally.
1
Code error
The monitor code not in the specifications was set.
Read/write of the point table of No.255 or later was set.
Read/write of the point table of No.255 or later was set.
2
Parameter point table
selection error
selection error
The parameter No. disabled for reference was set.
3
Write range error
An attempt was made to write the parameter or point table data outside the
setting range.
setting range.