Справочник Пользователя для Pelco IS310-DW

6

C3429M-A (1/08)

•

Mounting to a 2-gang electrical box

Figure 4.  Mounting to a 2-Gang Electrical Box

1. Some indoor installations do not require a heater. If the installation does not require a heater, 

disconnect the heater wiring.

a.

Remove the cover with the supplied 1/8-inch hollow screwdriver bit.

b.

Remove the camera from the mounting bracket, and unplug the 4-pin heater connector in the 
base.

c.

Reinstall the camera. If the camera has a varifocal lens, leave the cover off; it will be 
reinstalled later. Otherwise, reinstall the cover.

2. Connect the power input wires to the power wires of the IS310 base (refer to Table A). 

3. Connect the video cable/wires:

•

BNC: Connect the BNC connector from the unit to a mating BNC connector.

•

UTP: Connect the blue wire to Video +; connect the gray wire to Video -.

Table A.  Power Input

12 VDC 

+ 

Ground 

24 VAC 

~ 

~ 

2-GANG ELECTRICAL BOX

WALL OR
CEILING

ICS310-AP
ADAPTER 
PLATE (NOT 
SUPPLIED)

6-32 X 0.50 SECURITY SCREW 
(SUPPLIED WITH ADAPTER PLATE)