Справочник Пользователя для Pelco IS310-DW

8

C3429M-A (1/08)

1. Turn on power to the camera and monitor.

2. Release one or both locking rings, and swivel the enclosure until the angle of the camera is correct 

(refer to Figure 7). 

3. Tighten the locking rings.

Figure 7.  Adjusting Enclosure Position

4. If you have a varifocal lens, remove the cover with the supplied 1/8-inch hollow screwdriver bit.

5. Loosen the focal length and focus locking screws (refer to Figure 8), and then adjust the lens 

according to the scene detail.

Figure 8.  Varifocal Locking Screws

6. Retighten the screws.

7. Reseat the O-ring on the cover and reinstall the cover.

WARNING: Heater elements could be hot! When camera power is on, use caution when adjusting 
the camera. This applies to all models.

LOCKING RINGS

LOCKING 
SCREWS

VARIFOCAL LENS