Справочник Пользователя для Cub Cadet Z-Force 54-KH

! 

Battery posts, terminals, and related accessories 

contain lead and lead compounds, chemicals known 

to the State of California to cause cancer and 

reproductive harm. Wash hands after handling.

When attaching battery cables, always 

connect the POSITIVE (Red) wire to its terminal first, 

followed by the NEGATIVE (Black) wire.

For shipping reasons, both battery cables on your equipment 

may have been left disconnected from the terminals at the 

factory. To connect the battery cables, proceed as follows:
NOTE: The positive battery terminal is marked Pos. (+). The 

negative battery terminal is marked Neg. (–).
NOTE: If the positive battery cable is already attached, skip 

ahead to step 2.

Remove the plastic cover, if present, from the positive 

1. 

battery terminal and attach the red cable to the positive 

battery terminal (+) with the bolt and hex nut. See Fig. 3-6.
Remove the plastic cover, if present, from the negative 

2. 

battery terminal and attach the black cable to the negative 

battery terminal (–) with the bolt and hex nut. See Fig. 3-6.
Position the red rubber boot over the positive battery 

3. 

terminal to help protect it from corrosion.

NOTE: If the battery is put into service after the date shown 

on top/side of battery, charge the battery as instructed in the 

Maintenance section your Operator’s Manual prior to operating 

the tractor.

Install lanyard using existing self-tapping screw. See Fig. 

4. 

3-4.

NOTE: Insert self-tapping screw through hole in lanyard 

and down into the same hole that it was removed from.

The drive control levers of the tractor are lowered for shipping 

purposes. Using the hardware found in the manual bag, the 

control levers must be repositioned to operate the tractor. To 

reposition the control levers for operation, proceed as follows:

Lift and swing the control levers up into the operating 

1. 

position.
From the outside, insert the bolts through the hourglass 

2. 

spacers and the holes of the pivot bracket. Secure with the 

flange lock nuts. See Fig. 3-5.

Refer to “Adjusting the Drive Control Levers” in the 

3. 

Maintenance & Adjustments section for instructions on the 

final adjustment of the levers.