Справочник Пользователя для Cub Cadet Z-Force 54-KH

The ignition switch is located on 

the RH console to the right of 

the operator’s seat. The ignition 

switch has three positions as 

follows:
OFF — The engine and electrical 

system is turned off.
RUN — The tractor electrical system is energized.
START — The starter motor will turn over the engine. Release the 

key immediately when the engine starts
NOTE: To prevent accidental starting and/or battery discharge, 

remove the key from the ignition switch when the tractor is not 

in use.

The PTO switch is located on the RH console 

to the right of the operator’s seat next to the 

ignition switch.
The PTO switch operates the electric PTO 

clutch mounted on the bottom of the engine 

crankshaft. Pull the switch knob upward to 

engage the PTO clutch, or push the knob 

downward to disengage the clutch.
The PTO switch must be in the “disengaged” 

position when starting the engine.

1234.5

The hour meter/indicator panel is located on the RH console to 

the right of the operator’s seat. The hour meter records the hours 

that the tractor has been operated in the digital display.
The hour meter is activated whenever the ignition switch is 

turned to the “ON” position. Keep a record of the actual hours of 

operation to assure all maintenance procedures are completed 

according to the instructions in this manual and the engine 

manual.
NOTE: An optional meter provides engine speed (RPM), service 

reminders (oil, lube), and running time (hours).

SLOW

FAST

The throttle control is located on the LH console to the left of the 

operator’s seat. When set in a given position, a uniform engine 

speed will be maintained.
Push the throttle control handle forward to increase the engine 

speed. The tractor is designed to operate with the throttle 

control in the fast position (full throttle) when the tractor is being 

driven and the mower deck is engaged.

Pull the throttle control handle rearward to decrease the engine 

speed.

The choke knob is located on the left side of 

the mower next to the operator’s seat. The 

choke knob controls the position of the engine 

choke. Pull the knob out to choke the engine; 

push the knob in to open the choke.

The parking brake engagement lever is located on the LH 

console to the left of the operator’s seat., and when pulled to the 

rear, engages the parking brake.
NOTE: If the LH and RH drive control levers are not in the 

neutral position and locked when engaging the parking brake, 

the engine will stop. The parking brake must be placed in the 

engaged position when starting the tractor engine.

The fuel tanks are located to the right and left of the operator’s 

seat. Turn the fill cap counter-clockwise to remove. 

Turn the cap clockwise to tighten Always re-install the fuel cap 

tightly onto the fuel tank after removing.

Never fill the fuel tank when the engine 

is running. If the engine is hot from recently running, 

allow to cool for several minutes before refueling. 

Highly flammable gasoline could splash onto the 

engine and cause a fire. 

The seat adjustment lever is located below the front/left of the 

seat. The lever allows for adjustment of the fore to aft position 

of the operator’s seat. Refer to the Maintenance & Adjustments 

section for instructions on adjusting the seat position.