Справочник Пользователя для Cub Cadet Z-Force 54-KH

The deck lift pedal is located on the right front corner of the foot 

platform, and is used to raise and lower the mower deck.
To raise the mowing deck to the transport position, push the 

upper part of the pedal all the way forward and place the clevis 

pin in furthest hole from you and secure with the cotter pin. 

To lower the deck, remove the clevis pin and reinsert it in the 

desired cutting height and secure with cotter pin.

The RH and LH control levers are located on each side of the 

operator’s seat. These hinged levers pivot outward to open 

space to permit the operator to either  sit in the tractor seat, or to 

dismount the tractor. The levers must be fully opened out and in 

the neutral position and locked to start the tractor engine.
Each lever controls the respective RH or LH transmission. 

Consequently, these levers control all of the movements of the 

tractor. Driving and steering utilizing these control levers is 

quite different from conventional tractors, and will take some 

practice to master. Refer to Operation for instructions on using 

the control levers.

NOTE: References to LEFT, RIGHT, FRONT, and REAR indicate that 

position on the tractor when facing forward while seated in the 

operator’s seat. 

The deck height index consists of several holes located on the 

front/right of the foot platform. Each hole corresponds to a 1⁄4” 

change in the deck height position ranging from 1” at the lowest  

notch to 4” at the highest notch.

STOP

RUN

STAR

T

SLOW

FAST