Справочник Пользователя для Mitsubishi Electronics 60/60S

6.  Data In/Out 

6.1  DATA INPUT 

 

 

 

I-228 

 

(3)  Precaution for using 2-part system 

 

 

When using the 2-part system, the machining program input operation can be switched with the 
parameters. 

0, 2, 4, 6 

- 

 

The input machining program is registered in the memory 
common for the systems. 

1, 3, 5, 7 

OFF 

OFF 

The input machining program is registered in the memory for 
the selected systems. 

 

OFF 

ON 

The input machining program is registered in the memory for 
the selected systems. If the system is not selected, an empty 
(only EOR [%]) machining program is registered in the 
memory. 

 

ON 

OFF 

The input machining program is separated into machining 
programs for each system at the $ mark, and is registered in 
the memory for each system. 

 

ON 

ON 

The input machining program is separated into machining 
programs for each system at the $ mark, and is registered in 
the memory for each system. 
If the system does not have a $ mark, an empty (only EOR [%]) 
machining program is registered in the memory. 

 

(Example)  When parameter "#1050 MemPrg" is set to 1, 3, 5 or 7, and "#1286 ext22 bit0" is set to 1, 

the file (tape) delimited into systems with the $ mark is separated and input for each 
system. 

 

E 

E                  E        E                                      E                               E                           

E                    E                E  E 

O  O  O1234  O $1  O  N1 G28 X0 Y0 Z0  O  N2 G00 X100.  O  N2 

$2  O  G28 X0  O        O  O 

R 

B                  B        B                                      B                               B                           

B                    B                B  R 

Program body for System 1

Program body for System 2