Справочник Пользователя для Mitsubishi Electronics 60/60S

6.  Data In/Out 

6.4  PROGRAM COPY 

 

 

 

I-262 

 
 

The program number of a machining program registered in memory can be changed. 

 

To execute the number change command, set #4. Set the current and new program numbers in order. 

 

Press the 

 

 

INPUT 

 key. 

(Example) 
When O1000 is changed to O3000: 

#  ( 4 ) 

O  ( 1 0 0 0 ) 

→  ( 3 0 0 0 ) 

 
 
  # (    4 ) O (1000)

→O(3000) 

 
 

 

NO. CHANGE EXECUTION 

  # (    4 ) O (1000)

→O(3000) 

 
 

 

NO. CHANGE COMPLETE 

  # (        ) O (        )

→O(        ) 

1)  Number change processing is initiated 

with "NO. CHANGE EXECUTION" 
displayed in the message field. This 
processing is completed in a moment. 
Then, the message "NO. CHANGE 
COMPLETE" is displayed. 

 

 
 (Note 

1)  When using the 2-part system, the machining program number change operation can be 

switched with the parameters. 

0, 2, 4, 6 

- 

Of the machining programs registered in the memory common for the 
systems, the designated machining program will be registered in the 
memory common for the systems with a different program number. 

1, 3, 5, 7 

OFF 

Of the machining programs registered in the memory for the selected 
systems, the designated machining program will be registered in the 
memory for the selected system with a different program number. 

 

ON 

Of all the machining programs registered in the memory for each system, 
the designated machining program will be registered in each system 
memory with a different program number. 

2)  When using the 2-part system and the same number batch generation for all system programs is 

valid, an error (E64) will occur if the rename destination program is found in any of the systems. 

3)  When using the 2-part system and the same number batch generation for all system programs is 

valid, the program in the system having the rename source program will be renamed. Programs 
in a system that does not have the rename source program will not be renamed.