Справочник Пользователя для Mitsubishi Electronics 60/60S

11.    Visual Analyzer (Waveform display) 

11.2    Synchronous Tap Error Display 

 

 

I-374 

 

To display the error amount during synchronous tap, set either "6" or "7" in "#3 data" or "#7 data" and 
display the waveform. 
The operation methods and other setting items are the same as the normal waveform display. 

 

 

SINGLE AUTO DISPLAY 

 

 

[VISUAL ANALYZER] 

VISUAL ANALYZER 1. 

 

SYNCH ERR W (mm)    0.006  SYNCH ERR ANG (deg)    2.564 

#1 time 

(1000) 

(ms/div)  

5 

  2 CH1 ax 

( 1) 

 3 data 

(6) 

 4 range  (    6) 
 5 level 

(2) 

  6 CH2 ax 

( 1) 

0 

 7 data 

(7) 

 8 range  ( 6000) 
 9 level 

(-4) 

10 type 

( ) 

11 signal 

(      )  -5 

 
#(  )data(     )( ) 

 

 
 

(Note 1)  With the synchronous tap error display, only the waveform during cutting feed is displayed. 
(Note 2)  Data displayed in "SYNCH ERR W (mm)" and "SYNCH ERR ANG (deg)" on the screen indicates 

the maximum value of the synchronous tap error width obtained from the data displayed as a 
waveform. 

(Note 3)  The "SYNCH ERR W (mm)" is indicated as a value that allows for the gear ratio. 
(Note 4)  The "SYNCH ERR W (mm)" and "SYNCH ERR ANG (deg)" are displayed on the screen only 

when the spindle No. is set in "#2 CH1 axis" (or #6 CH2 axis), and 6 (synchronous tap error 
width) or 7 (synchronous tap error angle) is set in "#3 data" (or #7 data).