Справочник Пользователя для Mitsubishi Electronics 60/60S

2.  Start up and Adjustment Procedure 

2.1  Confirmation of Connections 

 

 

 

III-5 

 

 
 

Refer to Connection Manual (BNP-B2183) to confirm the connection of each unit and communication 
terminals, etc. 

 

Especially confirm the position of the input power and connection connectors, etc. 

 

It is recommended to leave the servomotor and spindle motor drive lines disconnected until the settings of 
the parameters, etc., is completed. 

 
 

 

 

 

 

 

  

 

 

Ground the signal cables to ensure stable system operation. Also ground the control unit main 
frame, power distribution panel and machine to one point, so they all have the same potential. 

 
 
 

 
 

1)  Control unit setting switch 

 

 

A slide switch (SW1) and rotary switches (CS1, CS2) are located in the window on the upper front of the 
control unit. 

 

 

Set SW1 to the "lower side" and CS1 to "0". CS2 is normally set to "0". Refer to the following settings if 
needed. 

 

 Switch 

 Operation 

 Application 

 

0 

Normal operation mode 

Normal operation 

 

1 

PLC program stop 

For PLC development work

 2  Not 

used 

 

 

3 

Maintenance mode for maker 

Do not use. 

 4  Not 

used 

 

 

5 

Maintenance mode for maker 

Do not use. 

 6  Not 

used 

 

 

7 

The entire memory will be erased, so do not set this. Do not use. 

 

8~F 

Maintenance mode for maker 

Do not use. 

 

 

 

 

 

 

  

 

 

If the control unit's rotary switch is set to "7", all data in the NC will be erased and the system will not 
start up.