Справочник Пользователя для Fortinet Version 3.0

This section describes:

•

•

•

•

Configure probe settings to control the response when a FortiBridge probe 
detects that the FortiGate unit has failed. Probe settings consist of:

This procedure shows how to configure the following probe settings:

•

The FortiBridge unit responds to a FortiGate unit failure by failing open and by 
sending an alert email, a syslog message, and an SNMP trap

•

The dynamic IP pattern is 2.2.2.*

•

The FortiGate unit serial number is FGT8002803923050

Log in to the FortiBridge CLI.

Action on failure

Set the FortiBridge unit response when a probe detects that 
the FortiGate unit has failed. The FortiBridge unit can.

Send alertmail

Fail open

Send an SNMP trap

Send a message to a syslog server

You can add up to four actions on failure. All of the 
configured actions on failure occur when the FortiBridge 
unit detects a failure.

fail open

Dynamic IP 
pattern

Configure the INT 2 and EXT 2 interfaces with dynamic 
probe IP addresses. The dynamic probe IP addresses 
should not conflict with IP addresses on the network that 
the FortiGate unit is connected to. These IP addresses are 
not visible from the outside network, but they should not 
conflict with IP addresses in packets passing through the 
FortiBridge unit. You cannot change the dynamic IP pattern 
if any probes are enabled.

(none)

FortiGate unit 
serial number

The serial number of the FortiGate unit that the FortiBridge 
unit is connected to. The serial number appears in 
FortiBridge alert mail, and syslog messages to identify the 
FortiGate unit.

(none)

Note: The FortiBridge unit does not have to fail open if the FortiGate unit fails. The 
FortiBridge unit can be configured just to send alerts if the FortiGate unit fails.