Справочник Пользователя для Fortinet Version 3.0

Log into the CLI.

Add the first SNMP community and name it snmp1. Enter:

config system snmp community

edit 1

set name snmp_1

end

The new SNMP community is enabled by default. SNMP v1 and v2 traps are also 
enable by default. You can disable traps and change ports. See 

 for more information.

Add the IP addresses of two SNMP managers that can receive traps. Enter

config system snmp community

edit 1

config hosts

edit 1

set ip 172.20.120.12

next

edit 2

set ip 192.168.20.102

end

end

After the FortiBridge probe detects a FortiGate failure the FortiBridge unit stops 
sending probes. To restart probes you can restart the FortiBridge unit, connect to 
the FortiBridge CLI and enter the execute switch-mode command, or press 
the mode button on the FortiBridge unit front panel.

Normally, an action on failure causes the FortiBridge unit to fail open. When the 
FortiBridge unit fails open, it begins operating in Bypass mode. In bypass mode 
the INT 1 and EXT 1 interfaces are directly connected and you cannot use Telnet 
or SSH to connect to the FortiBridge CLI. Use the following procedure to recover 
from bypass mode after a FortiGate failure and resume normal operation.

When the FortiBridge unit is operating in bypass mode, you need to do the 
following to resume normal operation:

Review FortiBridge alerts and check the status of your FortiGate unit and network 
components to determine the source of the failure.

A network component or the FortiGate unit could have experienced a general 
hardware failure or a specific software failure.