Справочник Пользователя для Zebra Technologies S4M
19
Printer Setup
Connect the Printer to a Power Source
10/21/05
S4M User Guide
13290L-001 Rev. A
Connect the Printer to a Power Source
The AC power cord must have a three-prong female connector on one end that plugs into the
mating AC power connector at the rear of the printer. If a power cable was not included with
your printer, refer to
mating AC power connector at the rear of the printer. If a power cable was not included with
your printer, refer to
To connect the printer to a power source, complete these steps:
1.
Turn the printer power switch to the Off (O) position.
2.
Refer to
. Plug the power cord into the AC power connector on the rear of the
printer.
3.
Plug the other end of the power cord into a power outlet near the printer.
Figure 6 • Power Connection
Caution •
For personnel and equipment safety, always use an approved three-conductor
power cord specific to the region or country intended for installation. This cord must use an
IEC 320 female connector and the appropriate region-specific three-conductor grounded
plug configuration.
IEC 320 female connector and the appropriate region-specific three-conductor grounded
plug configuration.
1
Power switch
2
AC power connector
1
2