Справочник Пользователя для DCS 500

IV A

  

4 - 2 

DCS 500B / DCP 500B Operating Instructions 

 

 

The general messages will only be shown on the seven segment 
display of the control board SDCS-CON-x. 

 

– 

Not available 

Program is not running 

– 

(1)

 

Not available 

Normal situation, no fault / no alarm signal 

– 

 

Not available 

Indication while loading another firmware 
into the drive 

– 

 

 

(1)   Units should be switched off and on electrically; if fault occurs again, the PCBs SDCS-POW-1 and SDCS-CON-x  
 

have to be checked and if necessary to be changed. 

 
 

The starting errors will only be shown on the seven segment display 
of the control board SDCS-CON-x. 

With starting errors it will not be possible to start the drive. 

 

– 

Not available 

ROM memory test error 

– 

(1)

 

Not available 

RAM memory test error 

– 

(1)

 

Not available 

No TC-link board 
(not valid for software version S21.1xx) 

– 

 

Not available 

Communic. board SDCS-COM-x faulty 

– 

(2)

 

Not available 

No control program in memory 

– 

(3)

 

Not available 

ASIC not O.K.  

– 

(1)

 

Not available 

Parameter FLASH identity test failed  

– 

(1)

 

 

(1)   Units should be switched off and on electrically; if fault occurs again, the PCBs SDCS-POW-1 and SDCS-CON-x  
 

have to be checked and if necessary to be changed. 

(2)   Check communication board, plug in correctly

 

and if necessary change the board. 

(3)   Load firmware once more. 

 
 
 

3ADW000055R0401_DCS500B_Operating Instruction_e_d