Справочник Пользователя для Sony LF-X1

F:\Joutou\#4090332_Sony_LF-X\4103221121up\4103221121\4103221121LF-
X1\00GB05C01-WW.fm

LocationFreeTV

4-103-221-12(1)

58

For example, you can register monitor B 
to base station A in following 
procedures.

Setting up base station A:
• Select [Wireless] under [Home]. (Refer to 

1 page 47).)

• Select [Enable] for NetAV. (Refer to “Start up 

• Set the base station to accept registration from 

monitor B. Write down the password for 
registration. (Refer to “Setting up for additional 
monitors” on this page.)

Setting up monitor B:
• Select [Wired LAN] or [Wireless] under [On 

the go]. (Refer to “Wired LAN Connection On 
the Go” (

1 page 48) or “Wireless Connection 

• Set IP address/domain name and port number 

to connect to base station A. (Refer to 
“Configuring the monitor to connect using 
NetAV” (

• Enter registration password acquired from the 

base station A setting, and select [Start] to 
register. (Refer to “Registering other monitors 
to the base station” (

Configure settings so that additional monitors can 
be registered to the base station, and so monitors 
can access the base station with NetAV.
Perform these settings on the base station and 
home monitor together.

In this section, you can also set whether to allow 
AV interception on a bound monitor.

Open the [Settings] window and select [Base 
station].
The [Base station] window appears.

Select [NetAV Settings].
The [NetAV Settings] window appears.

[NetAV Settings] can only be selected when the 
monitor is set to Home-Wireless mode. If you 
cannot select [NetAV Settings], check your 
monitor settings.

Select [Register other monitors].
The [Register other monitors] window 
appears.

Configure the following settings.

1

Select [Start].

2

Check this check box if you allow AV 
interception by registered monitors.

z 

The monitors currently registered to the base 
station are listed under [Registered monitors:]. To 
delete a registered monitor, select the check box 
beside the monitor, and then select [Delete].

An 8-digit password is created and appears 
on the screen.
You should write this password down 
because you will need it when connecting 
another monitor to the base station.

Select [Back].
The [NetAV Settings] window reappears.