Руководство Пользователя для Maytag mhwe300v

„

Mix large and small items and avoid washing single items. Load evenly.

„

It is recommended that you wash small items such as infant socks in a mesh garment bag. 

„

When unloading garments, occasionally check under the gray colored seal at the 
front of the tub for small items. 

2. Close the washer door by pushing it firmly until the lock clicks. The washer door will 

remain locked during the wash cycle. 
NOTE: After any wash cycle is completed, the door must be opened and then closed 
before a new cycle can begin. The door can be opened only if START/PAUSE or POWER/
CANCEL is selected while the status indicator is in the Add Clothes area or if the cycle has 
been canceled. See “To cancel a cycle” in Changing Cycles, Options, and Modifiers 
section.

3. Open the dispenser drawer and add laundry products to the main wash detergent, 

chlorine bleach, or fabric softener compartments. Close drawer slowly to avoid spills. See 
“Using the Dispenser.”

4. Turn on the washer by selecting POWER/CANCEL. Select one of the cycles by turning the 

cycle selector. The indicator light for the selected cycle will illuminate. When selecting a 
wash cycle, the preset Options, Wash Temp, Spin Speed, and Soil Level for the selected 
cycle will illuminate. The display shows the estimated time remaining. The preset settings 
provide the recommended fabric care for the selected cycle. See “Cycles.”

5. Select the desired Options, such as Max Extract

TM

, Extra Rinse, and Soak Time. Not all 

options are available with all cycles. See “Options.”

6. Select the desired Modifiers, such as Soil Level, Wash Temp, and Spin Speed. Not all 

modifiers are available with all cycles and options. See “Modifiers.”

7. If desired, select SIGNAL ON/OFF. The signal is helpful when you are washing items that 

should be removed from the washer as soon as it stops. 

8. To begin the wash cycle immediately 

Select START/PAUSE.

„

If you do not select START/PAUSE within 60 minutes of choosing a cycle, the washer 
automatically shuts off.

„

When the wash cycle is complete, the status indicator shows Done, the door unlocks, 
and the wash load can be removed from the washer. The washer powers down 
automatically 5 minutes after the cycle is complete. To power down the washer 
manually after the wash cycle is complete, select POWER/CANCEL once.

Your new washer has a dispenser drawer with three separate compartments for your laundry 
products—one is for detergent, one is for liquid chlorine bleach, and one is for liquid fabric 
softener. Laundry products are diluted and dispensed automatically at the proper time during 
the wash cycle, making it unnecessary for you to return to the washer during the cycle to add 
them.
It is normal for small amounts of water to remain in the dispensers when the wash cycle  
is complete.
Do not put laundry products directly into the wash tub. Always use the proper dispensers 
when adding laundry products.

Use only High Efficiency detergents. The package for this type of detergent will be marked 
“HE” or “High Efficiency.” This wash system, along with less water, will create too much 
sudsing with a regular non-HE detergent. Using regular detergent will likely result in washer 
errors, longer cycle times, and reduced rinsing performance. It may also result in component 
failures and noticeable mold or mildew. HE detergents are made to produce the right amount 
of suds for the best performance. Follow the manufacturer’s instructions to determine the 
amount of detergent to use. Remember, concentrated detergents such as 2x or higher will use 
less detergent based on load size.   

1. Pull out the dispenser drawer.
2. Add the desired laundry product to the proper compartment.
3. Push in the dispenser drawer slowly and completely (to avoid a spill).