Руководство Пользователя для LXE mx3
70
Symbol Barcodes
Integrated Scanner Programming Guide
E-SW-SCANNERPG-L
Host Character Time-out
Host Character Time-out Parameter Default Value
200 msec
This parameter determines the maximum time the decoder waits between characters transmitted by
the host before discarding the received data and declaring an error. The time-out is set in 0.01 second
increments from 0.01 seconds to 0.99 seconds. After scanning the barcode below, scan two numerical
barcodes to set the desired time-out.
the host before discarding the received data and declaring an error. The time-out is set in 0.01 second
increments from 0.01 seconds to 0.99 seconds. After scanning the barcode below, scan two numerical
barcodes to set the desired time-out.
To begin setting the time-out value, scan this barcode:
Host Character Time-Out
Next, scan two numeric barcodes that correspond to the desired value using the “Keypad Number
Symbols” at the end of this chapter. Single digit numbers must have a leading zero. For example, a
value of 300 msec is selected by scanning the “3” and the “0” numeric barcodes. A value of 30 msec
is selected by scanning the “0” and the “3” barcodes.
Symbols” at the end of this chapter. Single digit numbers must have a leading zero. For example, a
value of 300 msec is selected by scanning the “3” and the “0” numeric barcodes. A value of 30 msec
is selected by scanning the “0” and the “3” barcodes.
If you wish to change your selection, scan Cancel on the “Keypad Number Symbols” page.