Краткое Руководство По Установке для Ricoh ap204
Menu Settings
99
7
❖
3. Energy Saver
You can specify after how many minutes the printer should enter the Energy
Saver mode if no operation is performed. The Energy Saver mode reduces elec-
tric power consumption.
• Off
• 5 minutes
• 15 minutes
• 30 minutes
• 45 minutes
• 60 minutes
Saver mode if no operation is performed. The Energy Saver mode reduces elec-
tric power consumption.
• Off
• 5 minutes
• 15 minutes
• 30 minutes
• 45 minutes
• 60 minutes
Important
❐ After the printer enters the Energy Saver mode, it takes some time to warm
up again when print data is received.
❖
4. Transfer
You can specify the data transfer speed of the parallel interface. If you are
having trouble with data transfers, try changing this setting to “Normal”.
• Hi-speed
• Normal
having trouble with data transfers, try changing this setting to “Normal”.
• Hi-speed
• Normal
Note
❐ This setting is effective only for "Parallel 1".
❖
5. Image Memory
This setting controls what the printer does when the printer memory is not
enough to print a certain page.
• On
• Off
“Off” causes the message shown below to be printed when there is not enough
memory to process.
enough to print a certain page.
• On
• Off
“Off” causes the message shown below to be printed when there is not enough
memory to process.
Selecting “On” reduces the resolution of the image to reduce memory require-
ments.
ments.
❖
6. Parallel 1
You can specify the parallel interface timing setting. Normally it is not neces-
sary to change this setting.
• ACK inside
• ACK outside
• STB down
sary to change this setting.
• ACK inside
• ACK outside
• STB down