Краткое Руководство По Установке для Ricoh ap204
Remote Maintenance by Telnet (mshell)
71
6
System Log Information
Use the syslog command to display information stored in the printer's system
log.
log.
msh> syslog
Reference
For more information on the displayed information, refer to
⇒
SNMP
Use the snmp command to display and edit SNMP configuration settings such
as the community name.
as the community name.
Note
❒ You can configure from No. 1 to 10 SNMP settings.
❒ The factory default settings for No. 1 and 2 are as follows.
❒ The factory default settings for No. 1 and 2 are as follows.
❖
❖
❖
❖
Display
Shows the SNMP information and available protocols.
msh> snmp ?
msh> snmp [-p] [
msh> snmp [-p] [
registered_number]
Note
❒ If -p option is added, you can view the displays one by one.
❒ If the registered number is not added, you can view the status of all the reg-
❒ If the registered number is not added, you can view the status of all the reg-
istered numbers.
❖
❖
❖
❖
Community name configuration
You can set the community name of the Network Interface Board.
msh> snmp
number name community_name
Note
❒ The commmunity name must consist of less than 15 characters.
❖
❖
❖
❖
Access type configuration
You can select access type among those listed below.
msh> snmp
number type access_type
Number
1
2
community name
public
ricoh
IP address
0.0.0.0
0.0.0.0
access type
read-only
trap off
read-write
trap off